If you want to know more about the Wireless G internet Camera D-Link DCS-920 information, you could find on the type approval of Wireless G internet Camera device. So I’m going to inform you how to install the Wireless G Internet Camera D-Link DCS-920.

Hardware Installation

Connect the Wireless Antenna (DCS-920 only)
Screw the Wireless antenna onto the Internet camera’s antenna connector.

Connect the Ethernet Cable
Connect the Ethernet cable to the Internet camera’s Ethernet port and attach the other end of the cable to the network. Note: This step is necessary to configure DCS-920.

Attach the Power Adapter
Attach the power adapter to the Internet camera’s power socket and connect it to a power outlet.

The camera’s LED will light red when it receives power. The LED will light green after the camera connects to the network. The LED will flash green while accessing the camera.

Please refer to the Manual on the CD to install the software utility and finish installation.

Related posts:

  1. Wireless Notebook Adapter D-Link DWA-610
  2. D-Link DWL-3200AP Wireless Access Point
  3. Wireless Adapter D-Link DWA-510
  4. Network setup of Wireless G DWA-510 Desktop adapter
  5. Wireless G Router D-Link DIR 300